The water temp has raised above acceptable safety limits and triggered the safety “Watchdog” program of the spa system. The main pump operates in this condition to circulate warm water throughout the plumbing until the unit is warmed up to 15☏ (8☌) of the set temps. This only occurs when spa is in Economy mode and stands for “Ice ” means the system has detected a potential condition for freezing and will cause the system to implement freeze protection to get the spa out of the danger zone. No action required, but during cold weather you may want to increase the amount of filtration cycles. System activates the heater and jets pump 1 to bring temp within 15☏ (8☌) of set temps. Occurs only in Economy mode and Indicates a cool condition where temps have dropped 20☏ (11☌) below current settings for them. Contact dealer or a service technician if problem continues. After the pump primes itself, the error message should go away.ĥ. Turning it on will reset cycle for the circulation pump. If circulation pump is not powering on, try cutting off power at the mainīreaker. d) Replace the filter cartridge and verify the solution worked.4. c) Get an assistant to help turn the water on for 30 seconds. b) Hold a garden hose over filter cartridge wall fitting and utilize a rag to make a seal around hose end. a) Remove filter cartridge in order to purge the air lock from the circulation pump intake. Check for dirty or clogged filter cartridge.3. Check to see if the water level is below the lowest pillow but above the jets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |